Piping and Repiping Services in Utah
Your home’s pipes don’t last forever. Over time, pipe materials corrode, weaken, develop leaks, and eventually fail. If your home was built with galvanized steel, polybutylene, or aging copper, it may already be showing signs of trouble. Low water pressure, discolored water, frequent leaks, and visible corrosion are all signals that your piping system is wearing out.
The good news is you don’t always need to replace everything. Sometimes a targeted repair on a single section is all it takes. Other times, a full repipe with modern materials is the smarter long-term investment. Either way, Drain Kingz will assess your system, explain your options clearly, and handle the work with minimal disruption to your home or business.
We provide pipe repair, repiping, water line replacement, and slab leak repair for homes, restaurants, commercial properties, and property managers across Salt Lake, Utah, Davis, and Weber counties. Call (801) 335-9197
When Does Your Home Need Repiping?
Most homeowners don’t think about their pipes until something goes wrong. But the signs of a failing piping system usually show up gradually, and catching them early can save you from a major failure, water damage, or an emergency repair bill.
Low water pressure
If the water pressure throughout your home has dropped over time, the cause is often corrosion or mineral buildup inside the pipes. As the inside diameter narrows, less water gets through. This is especially common in homes with older galvanized steel pipes, where rust and scale accumulate over decades. If the pressure drop is isolated to one fixture, the fix might be localized. If it’s affecting the whole house, the pipes themselves are usually the problem.
Discolored or rusty water
Brown, yellow, or rust-colored water coming from your taps is a sign that your pipes are corroding from the inside. This is more than a cosmetic issue. Corroded pipes are weakened pipes, and they’re more likely to develop leaks or burst. If you notice discoloration every time you turn on the water, especially after it’s been sitting unused for a few hours, it’s time to have the pipes inspected.
Frequent leaks
One leak in an isolated spot is usually a localized repair. But if you’re dealing with leaks in multiple locations, or if a repaired section develops a new leak shortly after being fixed, the problem isn’t one bad joint. It’s a piping system that’s deteriorating throughout. At that point, spot repairs are just buying time, and a repipe becomes the more cost-effective solution.
Pipes older than 30 years
Different pipe materials have different lifespans, but most start to show their age somewhere between 25 and 50 years. Galvanized steel corrodes from the inside out. Polybutylene becomes brittle and prone to cracking. Even copper, which lasts longer than most materials, can develop pinhole leaks and joint failures over time. If your home is more than 30 years old and the original plumbing has never been updated, it’s worth getting an inspection to see where things stand.
Visible corrosion or damage on exposed pipes
Check the pipes you can see in your basement, crawl space, utility room, or under sinks. If you notice green staining on copper, flaking or discoloration on galvanized pipes, moisture at joints, or mineral deposits building up around connections, those are all indicators that the piping system is aging and may need attention.
Water damage or mold near plumbing
Stains on ceilings, warped flooring, bubbling paint, or mold growth near pipe runs are signs of an active or recent leak. Sometimes the leak is obvious and fixable. Other times it’s a symptom of widespread pipe deterioration. Either way, it needs to be evaluated before the damage gets worse.
Our Piping and Repiping Services
We offer a full range of pipe repair and replacement services. The scope of work depends on the condition of your existing system, the materials involved, and whether the issue is isolated or system-wide.
- Spot pipe repairs. When the damage is limited to one section, we cut out the affected area and replace it with new material. This is the most cost-effective approach when the rest of the system is still in good condition.
- Whole-home repiping. When the piping system has deteriorated to the point where spot repairs no longer make sense, we replace the entire system with modern, high-performance materials like PEX or copper. This eliminates ongoing leak risks, restores full water pressure, and gives you a plumbing system built to last.
- Water line replacement. The water line that feeds your home from the main supply can develop leaks, corrosion, or damage from tree roots and shifting soil. We replace aging or damaged water lines to restore reliable pressure and clean water flow to your home.
- Slab leak repair. Pipes that run beneath your foundation can develop leaks that are difficult to detect and access. Signs include warm spots on the floor, unexplained water bill increases, or the sound of running water when nothing is on. We locate the leak and access the pipe with minimal disruption to your foundation.
- Corrosion and leak detection. Not sure if your pipes need repair or replacement? We inspect your system to identify hidden corrosion, failing joints, and active or developing leaks so you can make an informed decision before anything fails.
- Poorly strapped or unsecured water lines. Pipes that aren't properly secured can shift, vibrate, and develop stress fractures over time. We re-strap and secure water lines to prevent future damage.
Repiping Materials
When it’s time for a full repipe, the two most common material choices are PEX and copper. Both are excellent options, and the right choice depends on your home, your budget, and your long-term goals.
We install both materials and will recommend the best fit based on your home’s layout, existing plumbing, and what makes the most sense for your situation. All installations meet or exceed Utah state plumbing codes.
What to Expect During a Repiping Project
A full repipe sounds like a major project, and it is, but it doesn’t have to be chaotic. Here’s how we approach it.
We start with a thorough inspection of your existing system so we know exactly what we’re replacing and what condition everything is in. From there we map out the new pipe routing, discuss material options, and give you a clear estimate with no surprises.
During the work, we open access points in walls, ceilings, or floors as needed to remove old pipe and install new lines. We work section by section and keep water service available as much as possible throughout the process. Most whole-home repipes take two to three days depending on the size of the home and the complexity of the layout.
After installation, we test every line for proper pressure and flow, check all connections for leaks, and make sure everything is functioning before we button things up. We also clean up our work areas and patch any access points we opened, leaving your home as close to its original condition as we can.
Residential and Commercial Piping Services
Pipe problems affect homes and businesses differently, and the repair approach varies depending on the building type, usage, and system layout.
Homeowners and Landlords
Restaurants and commercial
Property managers & HOA's
Why Choose Drain Kingz for Piping and Repiping
- Experience with all pipe types. Galvanized, copper, PEX, polybutylene, cast iron. We've worked with all of them and know how each one ages and fails.
- Custom solutions. We tailor every project to your home and budget. From single fixture repairs to full-home system replacements, we recommend what actually makes sense for your situation.
- Code-compliant installations. All work meets or exceeds Utah state plumbing codes. No shortcuts.
- Fast turnarounds. We work efficiently to minimize downtime and disruption. Most repipes are completed in two to three days.
- Upfront pricing. You'll know the full cost before we start. No hidden fees, no surprises on the bill.
- 24/7 availability. If a pipe bursts and you need help now, call us anytime at (801) 335-9197.
- Veteran-owned. Locally operated. Drain Kingz is family-owned by Jake and Payton, serving Utah homes and businesses since 2022.
Common Pipe Materials We Replace
- Galvanized steel. Common in homes built before the 1970s. Corrodes from the inside out over decades, causing rust-colored water, low pressure, and eventually leaks. If your home still has galvanized supply lines, repiping is usually a matter of when, not if.
- Polybutylene. Used from the late 1970s through the mid-1990s. This material was popular because it was cheap and easy to install, but it's known to become brittle and crack without warning. Many insurance companies flag polybutylene as a risk factor. If your home has it, replacement is strongly recommended.
- Cast iron. Found in older drain and sewer lines. Cast iron is durable but not permanent. After 50 or more years it corrodes, develops heavy scale buildup, and can crack or collapse. We see this frequently in older Utah homes.
- Aging copper. Copper lasts longer than most materials, but after 40 to 50 years it can develop pinhole leaks, joint failures, and corrosion. Homes with original copper plumbing from the 1960s and 1970s are reaching the age where problems start showing up.
- CPVC. Can become brittle over time, especially in areas with high heat exposure, direct sunlight, or where chemical cleaners have been used in the system. Brittle CPVC cracks easily during repairs or when fixtures are bumped.
Piping FAQ's
